RIP computer and Machine can't exist connected, what should I do?

When RIP Figurer and Machine cannot exist connected well or data transfer stop in the middle of printing, please follow the below information and cheque if the problem corrected or non.

Check the connection of the USB Cablevision

  1. Remove the USB cable at the cease of the Machine side and re-connect it again
  2. Remove the USB cable at the terminate of the PC side and re-connect it once more
  3. Switch USB socket on PC to another side if the PC has several sockets
  4. Checking cable status of the USB Cable that make certain no injure or whatever damage on the Cable
  5. Remove other USB devices if in that location are some devices connected

Checking standard of the PC and USB Cable

  • Checking of PC USB connector and USB cablevision are standardized USB 2.0
  • Checking standardized correspondence of USB2.0 of USB Cable. Standard length for USB cable is Max.5m. If cable length is not plenty from USB port of Car to PC, prepare extension cables. Check the USB connection if data transfer is no problem before using extension cablevision. (Extension cable cannot connect more than 3 cables, except JFX. (Extension cablevision cannot connect more than 2 cables for JFX)
  • Replacing USB cable with other 1
  • Checking of the PC specification. If PC Specification is non enough speed Automobile will wait the data from PC and sometime Head carriage become back to the Dwelling house position until enough data received.
    Information is received when printing mode is indicating in the Printer panel. During this time if the head carriage is stopped at habitation position 2 or 3 seconds or more than, mayhap printing information is not coming from PC quick plenty

    • Abroad from the electrical Noise

    1. Checking and moving some large machine which is created racket on electrical excursion and away from Mimaki Car
    2. Mounting ferrite cadre on the USB cablevision to remove noise on the USB Cable

    Other checks

    1. Trying performing of Data clear once
    2. Rebooting of the Machine and the PC
    3. Retrying printing of aforementioned data from spooling
    4. When Mimaki Raster Link Pro software is used, bank check correct Machine in the Raster Link Pro setting
    5. Open the Printer Management window of Raster Link Pro
    6. Check Printer proper noun and port See the Raster Link Pro Installation guide for the detail) ※ If multiple printers are connected to 1 PC, target motorcar could not observe because Motorcar name has aforementioned proper name. In case of this, switch / in the machine console and click on [Renew status] in Raster Link Pro
    7. If you notwithstanding have this error, please contact service.